Dawn Pluribus Strip-Till Unit Design Overview
This is the 2009 model unit w/ pneumatic down-pressure. Notice the deflection shield. It redirects the soil, ejected by the rear coulter, into the "Swirl" finishing tool.
This dry fertilizer tube will fit 2 in. hoses and blends dry product throughout the soil profile. It conveniently angles up, at the top of the linkage, to provide a smooth transition for hose routings. Often used for the incorporation of P&K, sometimes mixed with smaller quantities of dry Urea.
Part No. 300349_R2
This dry fertilizer tube will fit 2.5 in. hoses and blends dry product throughout the soil profile. This tube is for high output commodity carts and can accomodate several hundred pounds of product. It mounts on the opposite side of the row which aids in more thoroughly incorporating high rates of dry product.
Part No. 300349_R3
Below are the side banding dry fertilizer tubes. These tubes run in the slots created by the two primary tillage coulters and are a good option if you apply high rates of dry urea.
200910LH
Detail of the unusual Pluribus NH3 injection spring-tine. Used primarily for moderate rates around 120-140 lbs/acre. On a 16 row unit, a set of NH3 tines will last approximately 2000 acres before they require replacement.
Part No. 200877-V
This is a detail of the Pluribus "banding" liquid fertilizer tube. This setup is commonly used to band liquid in approximately a 4 x 4 placement relative to the center of the row. It is available for both the left and right hand side coulters. It cannot be used in conjunction with the NH3 tube.
Part No. 300348
Here is a detail of the Pluribus "incorporating" liquid injection tube. For 1/2 in. lines. This tubes,center mounted, placement allows the unit to thoroughly incorporate liquid into the profile of the soil, similar to it's treatment of dry fertilizer.
Part No. 300350
This photo is a closeup of the air bag down-pressure system, compactly mounted at the rear of the parallel linkage. It can generate from 0 to 600 lbs. of downforce. All pivot points on the Dawn Pluribus strip-till unit have replaceable synthetic bushings so there is never metal on metal wear. Use with a dedicated air system, or it may also be fitted with a standard Schrader valve for use with any portable air compressor.
Perhaps the most innovative strip-till closing system available, the swirl provides unparalled performance in the field. In addition to being a finishing tillage tool, the swirl also contributes to the thorough mixing of fertilizer into the profile of the strip. Soil is gathered in mid-air and directed up and in, forming a 1.5" to 2" parabolic berm.